Vive Lighthouse Tripod Angle Screw

Got a Vive? Got tall tripods? Wish you could angle them without tape and without complicated 3d prints? Now you can.

Thanks to Dean Westerburg for the source bolt and nut.

Shrunk and cut the bolt, angled, merged to two stacked nuts, and, Voilà - which is French for... "and then I found out," - a Vive Lighthouse Tripod Angle Screw.

(Do print 100%)

[UPDATE]: After a few months, these broke when moving them. This should be a TEMPORARY solution while you find metal. The vibration from the units may wear these down over time.