Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Hi everyone, I recently saw the "Aztec temple plant pot" print and thought it was a pretty good idea. But after looking at the parts I saw that there was not enough space inside and that the water couldn’t drain. So I hollowed out the parts, adjusted them a bit and added 2 areas for more earth and water. Also found a few DWGs of Aztec symbols and attached them.
Tip: The "Upper" and "Lower" parts can be glued, positioned together right in the slicer or plugged. When plugging you have to take care that the hole size fits exactly (easiest is to use the "horizontal expansion" setting in the slicer).
"Lower" part needs slim supports
I recomend PETG if used in sunny and moist environment (although the thing in the photo is made of PLA)
Comments