Skarky for OpenR/C Formula 1 (Driver/Cockpit)
episode, somehow Sharky has managed to hop into the cockpit of an
actual OpenR/C Formula 1 race car and drive away... naturally,
18 detailed parts including driver and cockpit to fit OpenR/C F1 compatible with Skarky Rail Rod for static display.
Arranged to print in color or easily be painted to achieve a variety
of cool custom looks. Doesn't require glue, but glue is recommend for
OpenRC applications. See assembly video on you-tube.
Print at 0.2mm, 15% in-fill, use support as indicated here.
Assembly Steps PART 1 - Sharky
pupils into eye whites.Locate
the teeth with NO TAB on the side and snap them into position at the
bottom of head shell by pushing all the way forward and down.
eyes into head so they fall into position notch down. Push all the
way forward into eye sockets.Drop
the tongue into head shell and push all the way down so the tab
protrudes from the hole in the neck area. Make sure it is all the
the teeth WITH TABS on the side into head shell and push all the way
forward. There is a groove inside the head to accept the tabs.Carefully
snap the tongue into the neck socket on Sharky's jacket. Twist a
little to help it snap into position. The head position is
the helmet over the head from the front and turn it to the correct
the chin strap into the slots on the both sides of the helmet.Carefully
screw one flame into the end of each exhaust pipe.Insert
the exhaust pipes into the four holes on both sides of the helmet.Make
sure the openings at the end of sleeves are clean and free of
support or other debris.Plug
steering wheel into open at top of steering column. Use a drop of
glue to secure it as needed.Clean
out the hole on the bottom of the skull shift knob slightly and
carefully bit the shift knob onto the end of the shift level.WITHOUT
PUTTING ANY FORCE ON THE FINGERS, carefully twist and slide the
hands into the position at the end of the arms. If you encounter
resistance, DO NOT FORCE IT, use sandpaper to so there is only
enough resistance to retain the hand. Make sure the hands slide all
the way into the sockets. Make sure the right hand cups the shift
Skarky into the cockpit of your OpenR/C F1. Secure with a 3mm
self-tapping screw from below.