Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
When I builded my printercabinet, I had a brainfart making of an spoolholder, what is attached on a rail and the rail is attached on the cabinets sidewall. Then the spoolholder could be moved from front to back ways if needed.
Rail: 280x41x10mm Rail holes: 3x4,5mm
SpoolHolder: 30x78,4/35x115mm Spool max. width: 90mm
31.1.2019 SpoolHolder with roller
Spool max. width: 84mm Bearings: 608 / d8mm / D22mm / B7mm x2
In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0,2mm
Infill:
10-20%
Filament: Real PLA / PETG
Notes:
Rail printed with 4 shells and 3 top/bottom. Holder 3 shells, 4 top/bottom.
In roller mode, I recommend to use sandpaper in bearing holes, because printing orientation might get those too tight. I myself putted main piece in hot water, then pressed bearings in place.
Comments