Garmin Nuvi 765 Sun Shade

Prints (0)


I built this for my wife. It slides on from the top and is a friction hold so don't pick up your Nuvi holding the shade.  SD card and power switch are both accessible. No interference with standard Garmin mount. Printed with 0.35mm/0.2mm layer height @ 205/200°C (1st/2nd +) , a 0.4mm nozzle, 2 perimeters-top-bottom, 15% infill, and 70 mm/sec. It takes about 3 hours and 13m of 1.75mm filament. I used black PLA. If you leave your unit in the window it is probably better to print with ABS. I didn't have any black ABS so I may have to print it again. Included is a test file if you need to verify your printer sizing. It take about 2.7m and 32 minutes to print.

Design Files

File Size

shade, Garmin nuvi 765 test.stl
70.7 KB
shade, Garmin nuvi 765.stl
794 KB


Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now