Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Collapsable/Adjustable Phone Stand
This phone stand is a print in place, which means you can print it in one peace without assembling it afterwards.
You can adjust the angle of your phone by just pulling it upwards. Phones with case work up to a 10mm thickness (which fits almost every modern phone)
I test printed this on an Creality Ender 3 without any difficulties using:
Nozzle: 0.4mm
Layer: 0.2mm
Speed: 60mm/s
Infill: 20%
Support: Yes
I printed in ABS, but PLA or PETG should work aswell.
Hope you enjoy.
For any questions or problems with the model send me an e-mail: [email protected]
Comments