Pumpkin Candy Dish

This is a small-ish, 130mm wide candy dish that I made for Halloween. This is my first ever attempt at using Blender, so... be kind :) 

Supports: Yes 

Resolution: 0.1 - 0.3 

Infill: 10% 

Notes: This needs [Supports Everywhere] turned on, especially for the lid. This will look best if you can print it in orange. Then, for the lid, you can pause the print as soon as the last layer of the pumpkin itself is printed and then switch to green filament. Slicing in Cura 2.6.1 at 0.3mm layer height, the pause was at layer 76, but your mileage may vary, so double check for yourself to be sure.