Prints (1)
Description
Hi, I made this gimbal for me and all people that want play and build own rc model like car or boat or other you think. Very simple but very durable compared to what appears. On video below I show all pieces and made small test :)
the sphere is critical piece and I decide to divide for good and easy print. In this other old preview video I show the assembly of sphere
Test it and report yours experience :)
suggest print conf:
- sphere layer 0.1mm , full infill, print as you see on video
- other pieces layer 0.1-0.2, full infill
-
If you think to buy from Gearbest and want support me, use my affiliate link, thanks https://www.gearbest.com/?lkid...
If you want to make a donation, you can use thingiverse tip, thanks https://www.thingiverse.com/Sg...
Check me out at:
- Youtube https://www.youtube.com/SgaboL...
- Instagram http://www.instagram.com/sgabo...
- Google+ https://plus.google.com/+Sgabo...
- Blogger http://www.sgabolab.com/
- Pinshape Shop https://pinshape.com/users/130...
Comments