No Prints Yet
Be the first to upload a Print for this Design!
SummaryPrinted this Deadpool and there is an error in the STL, the buckles on his shoulder straps are deformed or tear up during printing (noticed this in some of the "I made this" pictures also). I designed (using 123D Design) these to replace them. Simply using a sharp knife cut the old buckles off where they meet the belt and then print these. Once they are printed you may need to trim them to make them fit correctly. Now these were measured and printed for the size Deadpool that I did you may have to adjust the scaling to fit the one you print. Post-PrintingTrim them to fit the sides of the strap and then glue (weld with acetone if you're using ABS) them in place.