SummaryFILES HAVE BEEN CORRECTED. TEST PRINTING NOW. 9/9. If all goes well these files should be good. If you downloaded earlier I suggest downloading the new files. I adjusted some parts, added some more detail and re-cut the entire model. This is my full scale model of a police helmet from the movie The Fifth Element. I sized it to fit an average adult but have not tested the size yet. It was built in TinkerCad and is pretty close to the real prop. Print this out and also check out my Fifth Element Police Blaster which goes with this helmet. I hope you enjoy! Please note that the lenses are removable and can slide in the helmet tracks. This will allow you to make a mold of the printed lens and cast your lenses in blue like the movie helmets or you can cut and insert your own plastic sheeting into the lens slot.InstructionsThe stencils can be printed out and used to put the proper markings on your finished helmet. I've included full parts as well as cut parts you can print out and assemble for smaller build platforms.