Star Wars Sigelei 150W Sleeves

Prints (0)

Description

SummaryA sleeve that will fit your Sigelei 150W Vaporizer. Done in Empire and Rebel logos.Print SettingsPrinter: Prusa Mendel I3Rafts: NoSupports: NoResolution: 0.2 or 0.3mm layer heightInfill: 20%Notes: Empire I recommend at least the 0.2mm layer height. 0.3 is fine for the Rebel Alliance logoPost-PrintingBreak it inBe prepared for it to be tight until you have taken the unit in and out a few times. To safely remove your unit if it is too tight you should use a screw driver or pusher rod to push the unit out from the bottom by holding the screw driver in the bottom hole while holding onto the case. you may need to apply a dynamic force like a hammer blow if it is very tight. After a few times, it will fit fine.How I Designed ThisDesigned in Google Sketchup

Design Files

File Size

sigsleeveREBEL.stl
1.08 MB
sigSleeve150WEmpire.stl
1.07 MB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×