Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryA fitted sleeve for your Joytech EVIC vaporizer.Print SettingsPrinter: Prusa Mendel I3Rafts: NoSupports: NoResolution: 0.3Infill: 20%Post-PrintingBreak it inBe prepared for it to be tight until you have taken the unit in and out a few times. To safely remove your unit if it is too tight you should use a screw driver or pusher rod to push the unit out from the bottom by holding the screw driver in the bottom hole while holding onto the case. you may need to apply a dynamic force like a hammer blow if it is very tight. After a few times, it will fit fine.How I Designed ThisMade in Google Sketchup. Hardest thing was designing for the sloping surface from bottom to top.
Comments