Riddler Trophy - Batman Arkham Asylum

Probably the most iconic game prop in the entire Batman Arkham franchise, when I saw the official version I desperately wanted one but they were expensive and hard to find. 

Sometime later I got around to modeling the trophy and printing one and this is what I came up with. It may not be the best way to build one but it's how I got it done.

It was designed to use stripped elwire  that runs through channels in the question mark. Theres a compartment underneath to store electronics and pathway to route the cables from the compartment to the lamp holder. You can reference this short video I took a while back to see what I mean by stripping the elwire.

VIDEO: youtu.be/ahcQ8vJMmAA

 

RECOMMENDED MATERIALS:

El-Wire Green - amzn.to/3btooTQ 

PLA Green - amzn.to/2JmqybM 

PLA Silver - amzn.to/3dzTFq4 

Raise 3D Printer - amzn.to/3aqoH1t 

Soldering Kit - amzn.to/2UCexnU 

Acrylic Paints - amzn.to/39mLNFc 

Bob Smith Super Glue - https://amzn.to/3aqG5Dg

Recommend printing high infill and perimeters for the base maybe 30% infill so its heavy and less prone to knocking over.

NOTE: Some aesthetic and minor improvements were made to the design since some of the photos were taken nothing major.