Prints (-2)
Description
Hello Doctor Who fans.. this model was build for the 50th anniversary of the TV serie to be the representative of the infamous nightmare creature known as 'the weeping angel'. Don't forget... DO NOT BLINK or they will kill you..
recommander parameters : 0.2mm layer, 10% infill, 2 perimeters,truly Optimized for FDM printers - No support Needed.. and not too much speed if don't want to break the hands.
note: there is an internal support under the jaw that you need to remove (use tweezers or cutter, it's easy)
NOTE 2 : I put an updated v1.2 version of the model. there was a little error in the back of the v1 : the robe was ON the wing near the foot. Now it's corrected (finally)
NOTE 3 : Updated to v1.21. a little bit of the back of the wings was not correctly supported in the v1.20. Corrected
Comments