Rope Bridge 28mm

Prints (0)

Description

Simple rope bridge for table top gaming. Every two boards count as one square. Bridge is considered 2 squares wide. I printed the rope bridge part out of flexible TPU so to get a bit of droop and not be rigid... But could be printed in PLA as well. 

In the picture I have it across a river. However I like to use this across a chasm, or a lava stream. I then get my players to fight mid bridge and make regular balance checks as to not fall off (since a rope bridge would sway quite a bit with a fight going on, on it).

Design Files

File Size

Bridge_base.stl
845 KB
Rope_Bridge.stl
790 KB
Post_Caps.stl
41.1 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×