Wowstick Stand for 1F+ 64pcs set

This is my version of a stand for my Wowstick 1F+ for the 64pcs set. 

In my print, I discovered the tolerances were a little too tight so I had to sand a little. I adjusted the model to give more space but it's ok to print 101% or 102% to avoid any issues.

There is 2 pieces to print, the base and the clip which attaches to the base (glue or no glue, up to you) and then clips onto the wowstick to keep it steady. (see pics)

There is 2 versions of the base, one with the Wowstick logo and one without.