No Prints Yet
Be the first to upload a Print for this Design!
This product was designed to provide a even more minimalist design than the original. This is evident because the product uses way less material on the edges and corners and still accomplishes the same task.
- Instructions for 3d Printing:
- 1. First make sure you have your file in the correct measurement (inches)
- 2. Then upload the file to a usb and plug it into you 3d printer, if you have a wireless 3d printer then you can send the file over to the printer without a usb drive.
- 3. Before starting your print follow your printer's instructions for unloading an reloading the filament. For a makerbot replicator unload the filament by pulling up the slot and pressing on the lock. Then press on the spool lock to release the spool, but make sure before unwinding the line of filament that you have a good grip on the line and wrap it on the spool. Make sure to lock the line in the line slots on the spool before storage, and then install the spool of the color of filament you want to use and push the filament line into the tube that extends into the extruder. Load the filament into the extruder make sure it is heated to the required temperature and push the filament into the slot on the top of the extruder. Once the filament line catches and the extruder changes color you can start to print.