Designed by
KrisCubed
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
This is my 3D printed RC car.
Recommended print settings:
.4mm nozzle | 210*C print temp | 30%infill | 4 outer perimeters | .2mm layer height
-BOM attached.
-Instructable coming soon.
Video: https://www.youtube.com/watch?v=8XEKoBt0MZI&t
See what I am working on: https://www.instagram.com/engineeringns/
Design Files
File Size
Drive Gear.stl
772 KB
Gearbox Chassis - Bottom.stl
419 KB
Gearbox Chassis - Lid.stl
349 KB
Chassis - C Chassis.stl
748 KB
PLA bumper - Right half.stl
444 KB
Spring Mount - Front.stl
234 KB
Steering Linkage - Steering linkage (print 2).stl
85.2 KB
Steering Linkage - Steering rack thingy.stl
273 KB
Upper Control Arm - Right.stl
113 KB
Wheel hub - Hub end.stl
1.11 MB
Upper Control Arm - Left.stl
113 KB
Wheel Hub - Wheel end.stl
202 KB
Front Wheel Hubs - Right.stl
1.24 MB
Lower Contorl Arm - Left.stl
200 KB
Lower Contorl Arm - Right.stl
200 KB
PLA bumper - Left Half.stl
331 KB
Rear Bearing Hub.stl
305 KB
Dif-Mount - Print 2.stl
260 KB
Motor Mount - Offset MM.stl
451 KB
Part Studio 6 - 2-2.stl
173 KB
Output Gear - X pattern.stl
1.11 MB
Tourque Damper - Torque damper output.stl
2.96 MB
Front mount - Drive gear mount.stl
822 KB
Chassis - F Chassis.stl
738 KB
CV Axle v3 - CV-Axle.stl
5.77 MB
Rear A Arm Bracket - R A-Arm Mount.stl
474 KB
Lower Control Arm - Rear.stl
397 KB
CV Diff Adapter - CV Power Delivery Cup.stl
1.92 MB
Upper Control Arm - Rear.stl
575 KB
Front Wheel Hubs - Left.stl
1.25 MB
Spring Mount - Rear Low.stl
191 KB
Buper Bracket - Bracket.stl
673 KB
Front Control Arm Bracket - Single V2.stl
563 KB
Tourque Damper - Torque damper input.stl
2.83 MB
Front Steering - Swivel Mount.stl
412 KB
Diff 2.07-1 - Diff Drive gear.stl
341 KB
Drive Gear DIRECT.stl
2.59 MB
Gearbox Shaft replacement - (If not using torque damper).stl
70.4 KB
Diff 2.07-1 - Diff drive housing.stl
1.5 MB
Diff 2.07-1 - Diff lid.stl
168 KB
Diff-Case Lid - Lid.stl
219 KB
Comments