Yu-Gi-Oh Card Trophy/Stand - REMIX

Summary I printed the original card holder (which is a great design), but it barely seemed to hold the card in place, so I designed this replacement holder which fits the original stand. Just print 2 and slide them together. They may need a little sanding, mine have all had little peaks on one end where the nozzle lifted and left a small glob. I'm using a similar design to make a Magic the Gathering holder.. but it's not ready yet. Print Settings Printer: Da Vinci 1.0 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Notes: This would probably come out much better at 0.1 layer height, but since I'm just prototyping, I haven't used that setting yet.