Anet A6 : Auto Leveling bed AND Cable chain !

Prints (0)

Description

Summary Hi, This is a great improvement for the Anet A6 printer : 3D parts for holding a promity sensor diameter 18 (Ref. LJC18A3-H-Z/BX NPN NO, from eBay) AND a cable chain with both end that fit printer and sensor holder. You will also find the "configuration.h" file that is needed for Skynet Marlin firmware for Anet V1.1 board. This file contain exact settings for the Anet A6 (Skynet provide one for Anet A8 only at the moment), and particulary the good offset dimension "nozzle to sensor" for this particular proximity sensor holder part. To replace the Anet proprietary firmware with Malin firmware, check the very good (and functionnal) work made by Skynet3d here : https://www.facebook.com/skynet3ddevelopment/ Don't forget to replace "configuration.h" file by this one for A6. Print Settings Printer: Anet A6 Rafts: No Supports: Yes Resolution: 0.2 Infill: 50% Notes: No troubles to print theses parts. You will need about 13 parts of "Cable Chain Left" and 13 parts of "Cable Chain Right". You have to alternate them when assembling (see pictures). Post-Printing Sensor Holder... Pay attention to the lower right screw of nozzle fan : you don't need the nut anymore, it screw directly in the plastic part (don't screw too hard !!). The upper left screw still need his nut.

Design Files

File Size

Cable_Chain_Nozzle_end.stl
311 KB
Cable_Chain_Left.stl
445 KB
Cable_Chain_Right.stl
445 KB
Cable_Chain_Out_End.stl
752 KB
Proximity_Sensor_D18_Holder.stl
934 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×