No Prints Yet
Be the first to upload a Print for this Design!
Summary Similar to my Pi noIR Case, even uses some of the same parts, but includes openings for IR LED reflector/holders that I got from Adafruit: https://www.adafruit.com/products/2178 . Also, extensions to position the camera, can print multiples to get the configuration needed. In pictures, shown mounted to my PrintrBot Simple Metal Stabilizing Feet. I use this setup to monitor my PrintrBot Simple Metal over my LAN using AstroBox for Raspberry Pi 2 and AstroPrint: https://www.astroprint.com/downloads Print Settings Printer Brand: Printrbot Printer: Simple Silver Rafts: No Supports: No Resolution: 0.3-0.2mm Infill: Sure - if you want Notes: Pick the material you like, should print good flat with no support. Hex opens are for standard 1/4"-20 NC bolt or nut, standard hardware on tripods. All other holes are for 3mm hardware, but you can drill the holes and use available bolts and nuts.