bq ciclop remix with T slot extrusion and LED lights

These is upgraded version of the scanner with T-slot frame with LED lights and RF Remote Controller for LED light up on the object for perfect scans. Assembling is same as the original bq, just instead of long screw in this remix I used T-slot extrusion and modified the parts to fit the extrusion, however, and the back cover is modified and using now magnets instead slots to hold in place.

STL are prepared for both ABS or PLA

The Ciclop 3D scanner is a 100% open source project. As with all products of the BQ DIY ecosystem,

Ciclop and Horus have been made freely available under CC-BY-SA and GPL.

  All information on the mechanical design, the electronics, and the software have been made freely available to the community, to become part of the Technological Heritage of Humanity. Easy to build, the new BQ Ciclop is a 3D rotational laser triangulation scanner.

It uses 2 lasers projected over an object to capture the geometry and texture as it rotates on a turntable.

Ciclop is a DIY scanner. It requires manual setup, however, this makes it possible to accurately calibrate the device for your intended use thus achieving optimum results for your particular task.  

Need the T-slot pre-cut parts and LED light ready for assembly find here: http://asterosltd.bigcartel.co... Need the printed parts and T-slot pre-cut parts ready for you find here: http://asterosltd.bigcartel.co... Need this scanner full kit find here:http://asterosltd.bigcartel.co...

Check also my other items here : http://asterosltd.bigcartel.co... Or visit my eBay shop : http://stores.ebay.com/asteros...