Robo 3D Gopro Print Monitor Swing/Tilt Bed Mount

SummaryUse a Gopro Hero 3 to wirelessly monitor prints and or take video and timelapse. This is an easy pressure-fit plate Gopro mount for Robo 3D. It will probably work with other 4mm glass beds. It is orientable and hand tightens with the included special swing knobs.You will need 3 1/4" Bolts, 1/2" to 3/4" long and 3 1/4" nuts, and a standard GoPro knob/nut.Print SettingsPrinter Brand: Robo 3DPrinter: R1 ABS + PLA ModelRafts: NoSupports: NoResolution: .3Infill: 20%Notes: Use standard 1/4-20 nuts and hex bolts. M6 may also work. Position the GoPro frame in the yoke and push through a short hex bolt (1/2" to 3/4" long) on each side. Depending on which way you orient each of the swing knobs, they can be either trapped or removable without unthreading the nut. Push the third hex bolt though the bottom of the yoke and seat it. This bolt goes through the bed plate clamp and is snugged in place underneath with the third swing knob. This design allows access to the usb, sd card slot, start/stop and wifi buttons, when the camera is inserted upside down (as shown). The mini hdmi, however, is inaccessible, so use a different design if you want an hdmi feed.