No Prints Yet
Be the first to upload a Print for this Design!
SummaryThis is a hook designed for the Skywalker X5 for use with a Bungee Launcher. Instructionsfind a suitable location on the underside of the x5 in-front of the CG (Centre of gravity) and mark the extruding foam needed to be cut out, after the foam has been removed fix the X5 hook to the bottom using double sided tape to hold in place. use a 3mm long drill bit and push it through the X5 hook hole and turn by hand slowly with little force until you break through into the compartment bay (Keep the drill bit as vertical as possible. repeat for all 4 holes. insert 4 x M3 long enough screws through the X5 Hook into the compartment bay. place the X5 inner plate over the screws and using 4 x M3 Nuts tighten until t pinches the foam on both sides