Star Wars Coins - Modular Insert Design

The dark side and the light side are just two sides of the same coin, right? At least they are in this case.

This is a simple modular coin design that consists of 3 parts: 1 rim and 2 inserts. I have included a blank for remixing or gluing your own designs to the coins as needed. The finished coins have a 36mm diameter and are 4mm thick.

The inserts are just the right size to snap into the rim and stay in place. When installed, the inserts have a little bit of play. This was to allow for various printer capabilities. If you don't like the bit of wiggle room that is left, you can put a small piece (or two) of standard office paper in between the inserts to get rid of the movement.

If you print this, be sure to share and tag @andrewbougie on Twitter and Instagram. I love to see what others do with my models!

Print Settings

• Printer: Printrbot Simple Metal  
• Rafts: No 
• Supports: No 
• Resolution: 100 microns 
• Infill: 25% or solid

Notes: I printed these in PETG which may make it easier to snap the inserts into the rim without breaking them. It should work fine with ABS or PLA, though.