Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
This is a custom card guard for bicycle/tally ho and similar playing cards. If you use simplify 3d you can easy adjust it to fit any card case.
Watch the entire process below ;) https://www.youtube.com/watch?v=5QwwC2_XA-c
Printer: Rostock modified
Rafts: Doesn't Matter
Supports: No
Resolution: 0.3 mm recommended but can go lower if you wish
Infill: 10 - 20% or every layer 100% , it's up to you ;)
Notes:
This model was printed in ABS on 265 celsius for hotend and 110 for heatbed to make sure there would be no cracking in ABS. Make sure to print with a larger brim to avoid material curling on the bottom layer during print.
Comments