Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryI needed a way to mount the arm of the Tarot to the anti-vibration plate on the Phantom quadcopter, above the anti-vibration plate. The arm is so long that the GoPro3 would hit the ground otherwise. I also made a mount for the controller board that friction fits the roll control brushless motor. InstructionsMakerbot Replicator (1) MakerWare 2.3.0.4 Printed with clear ABS; 50% fill 4 shells .2mm layer The Board Bracket needs to be printed with supports and rotated so the 4 cylinders are on the build plate. This makes for a smooth connection to the roll control brushless motor. I designed the 4 cylinders to accept a #2 1/4 screw from McMaster.com. It's a small fastener but does a great job. The drawing was done in Cubify Invent. Good, easy, and only $50
Comments