Standard AR-15 Lower Receiver

For more info, check out post on Cults3D https://cults3d.com/@MS_Studios

!!!PROMO CODE FOR 25% OFF : MERICA

For educational and display purposes only, THIS IS NOT TO BE USED! Threads are there and accurate. For .223/5.56 ar frame

Disclaimer: This model is for reference and educational purposes only. Any other use (including printing) of this specific model is done at your own risk. The website and I will not be held liable for any injury or damage caused by inappropriate use. All models uploaded are in and will remain in digital form. By downloading this model you are acknowledging the above.

Layer height ideally <= 0.15mm Supports required: tree supports recommended - all holes except large few don't need supports, see image 8. Preferred to print flat on the mag opening Likely needs a brim due to small first layer area Use a gluestick as well to improve adhesion (Elmer's disappearing purple gluestick does amazing.