Ultimate Spool Holder Holder

I designed this end for the TUSH ultimate spool holder to keep it from toppling over. It fits nicely if your dimensions are dialed in.

http://www.thingiverse.com/thing:2047554

The 57mm version is meant to fit a spool with an average width of 57mm. (SUNLU) The 47mm version is meant to fit a spool with an average width of 47mm. (PolyFlex)

Make two, one for each end. I printed this with PLA, layer height of .2mm, and 20% infill.

The file SpoolPad.stl is for the bottom to prevent the rollers from sliding on the table. Print this with TPU and hot glue it to the bottom to keep them from sliding.