Tantō Headphone Stand - 3D Printed by rethys
1458
Printer Used
My Rating
My Thoughts
This was printed on an Flsun i3 clone, not in the list. The stand is larger than I expected and for most headphones could be printed at 75% scale. It prints well, but any elephant's toe will ruin the mating surfaces, so printing at the lowest temperature supported by the material with the lowest bed temperature is better. However, the best orientation is often not the largest surface, so a brim is helpful.
Settings
Print Time
24
hr(s)
0
min(s)
Material Brand
Maker Geeks and Foxsmart
Material Type
Crystal PLA Blue and PLA Brown
Material Rating
Layer Height
1.5
mm
Print Speed
45.0
mm/s
Extrusion Temperature
205/195
°C
Infill %
20.0
%
Supports
No
Comments