Hairy Einstein - 3D Printed by rethys
1236
Printer Used
My Rating
My Thoughts
First of all, this was printed on a Kodama Trinus, which isn't a choice in the printer dropdown. This is a very difficult print to complete on the Trinus using PETG because the filament calls for 255c, and the Trinus firmware only allows 250c. I had to turn off retract completely because the hair was causing the nozzle to repeatedly jam up. I suspect it would print without a problem using PLA. I wanted to insert LED lighting inside, so I hollowed out the model in Meshmixer before printing. I'll add a picture of that when I get it done.
Settings
Print Time
14
hr(s)
22
min(s)
Material Brand
Makergeek
Material Type
Crystal Natural PETG
Layer Height
2.0
mm
Print Speed
35.0
mm/s
Extrusion Temperature
250.0
°C
Infill %
0.0
%
Comments