Terminator Arm (inches)

My attempt at an accurate movable terminator hand. I made this in Sketch up and models must be imported in inches to be the correct size. They are named as close to actual anatomy as I can figure to help in assembly. Also 1 is thumb 2 index ect.. 1/8 in rod cut to 5/8 in pieces will hold most of it together pretty tight or you can use screws and run cables through the pulleys to make it move if you want. I am working on simplifying the construction of the model still.

For example a file labeled 2345 would be the same for index2 middle3 ring4 and pinky5 so you would need 4 of those. If there is more than one number in a file name it is a piece that is the same for multiple fingers. Example to assemble ring finger (4) you would need 2-4_proximal_phalanx, 2345_meticarpal_phalanges, 4_medial, and 2345_distal_phalanx for the main 4 pieces of the ring finger