Reptile S800 Sky Shadow Motor Mount

This mount will move the motor back 11 mm into cleaner air so it runs quieter.  It will accommodate a 6 inch propeller, possibly 7 inch, depending on the height of the motor.

Print in PETG for strength and heat resistance.  I recommend 0.4 mm nozzle, 0.2 mm layer height, 3 perimeters, 30% infill.

Ream the holes with a 3 mm drill bit.  Mount with 16 mm M3 bolts and nuts.  I epoxied the nuts into the S800 wooden motor mount, taking care not to get epoxy on the threads.  Then I glued the carbon fiber plate over the wooden plate, again taking care to keep glue off the threads.