No Prints Yet
Be the first to upload a Print for this Design!
I just made this headphone holder/ organizer.
The Funktion ist very simple. For using, you need to lay the headphones into the recess, afterwards just wrap the cable . The teeth was made for to fix the end of the cable.
To unwrap the headphones, just unfix the endpart of the cable out of the teeth, hold the headphone organizer between your thumb and index finger and just pull the cable, so this gadget will spin between your fingers
Due to the symmetric design, theres is just one "half". Just print it twice and put them together.
Attention: this organizer was especially made for in-ear headphones, because of the recess.
Of course you could use it for other headphones aswell, in this case you need to consider to scale the parts with your slicer a bit bigger.
Hope you enjoy it.