Thermaltake Core V21 Rear Legs

Some very simple legs for propping up your Core V21 case on it's back! It raises the case 80mm off the surface of your desk, allowing for plenty of room for the power cable and anything plugged into your motherboard to run below and out the back. The legs require no modification to the case; simply screw the case panel thumb-screws into the holes of the legs and viola! You're ready to stand tall. 

Print settings: 

0.2mm layer thickness, 190C extruder, 60C bed, printed with PLA. Orient the legs on their sides when slicing for best results.