Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
-
Drag & Drop A Photo or
Click To Browse
Description
Printable STL file for a Cable organizer capable of holding up to 5 cables in place. Will fit cables approximately 4-5 mm in diameter (i.e. most charging cables, network cables, HDMI/display port, etc). Includes two mount screw holes for screws of about 3 mm diameter. Prints best with raft to limit warping. No support material required. Edges where cords "snap" in are rounded to avoid damaging cords. If cord is too small, tape can be wrapped around cord to make fit, however I have not had trouble getting cables to fit. Best to print in orientation shown in screenshot.
Comments