No Prints Yet
Be the first to upload a Print for this Design!
Summary I took the original design into Fusion360, and cleaned it up a bit, shortened it to save some print time and material, rounded the edges, expanded the mounting plate, added a couple of holes for zip ties, and shaved the 2020 mount to be a little easier to get onto the rail as there were clearance problems with the original design. I kept the tabs so that the linear rails will push the camera up as necessary as that's what drew me to the original design. Print Settings Printer: Anycubic Kossel Linear Plus Rafts: No Supports: No Resolution: .25 Infill: 10% Notes: Printed with PETG as it is flexible enough to snap into place on the rail, and stay. I also printed it mirrored so that I could put the camera on the right side of the rail. Post-Printing If you have trouble getting it onto the 2020 rail, I used a heat gun to soften it up a little bit and get it to click over the rails. The mounting holes are 45mm apart which accomodates the Logitech C270 pretty well. It should work on other similar cameras as well.