Modular Hex Drawers

Summary Featured on MyMiniFactory! Also see The HIVE - Stackable Hex Drawers The HIVE is a fully stackable version of these modular hex drawers This is an extension of my Modular Wine Rack. I noticed my wine rack could also make great stackable drawers. The hex modules are 75 mm long and 75 mm wide. More Modular Drawer Systems The HIVE - Stackable Hex Drawers (Interlocking) Modular Drawers 2.0 (Interlocking) Modular Drawers 1.0 (Stackable) Economical Drawers (Not modular) Find me on: Update 2/19/2017 I removed the stacking piece because it is a waste of filament compared to my HIVE drawers which interlock. If you need to stack in a honeycomb pattern I recommend you print the HIVE drawers instead. Update 06/07/2016 Later in the day I uploaded the module with a back and the drawer with a separator. Update 06/08/2016 I uploaded both the voronoi module and the voronoi module with a back. I also uploaded dual modules. Update 06/09/2016 I uploaded the voronoi dual modules and the dual modules with a back. Update 06/15/2016 I uploaded the module stacker. This addition makes for easier stacking. Update 08/2/2016 I uploaded the wall mounting module with the tab. The tab is reversible so that the module can be mounted from the inside or the outside. I made a special module for mounting with tabs on the inside. It is 3mm taller than the others. I also included another drawer. Update 09/13/2016 I uploaded a larger module and drawer. 100 mm in height and width. Print Settings Printer: Maker Select V2 Rafts: Doesn't Matter Supports: Yes Resolution: 100-200 microns Notes: Print modules at 102% to compensate for tolerances. If you print as is they will not fit due to expansion of material.