No Prints Yet
Be the first to upload a Print for this Design!
Hey drummers. Tired of having to run to the music store to buy new sticks when you break them? Save gas, time and money by printing them yourself.
I printed the tip and handle on their side for strength. I used a raft instead of a brim to keep the print from warping and lifting off the print deck. If you print them standing up it gives the sticks tons of shear points. I recommend printing the splice piece standing up so there are no supports on the inside. It seems to hold together fine. I printed using PLA with layers at .250mm and raft the same. The walls are 1mm thick and use 4 loops.