Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
I have made this soap holder to drain the water inside the sink not all over. It has sloped drain that will collect the water to the main spout which will drain in the sink directly. Also the spout angle prevents the holder to move backwards from the sink.
The soap also sits on the sloped curved area to keep it in place.
I print it with PLA and then paint it. The infill was 20% and the lowest resolution 0.35mm. Please note this is a large holder so you can scale it down if you need.
The pictures were taken after 6 months so there is some wear on the paint which was a poor choice (used paint for scale models) of material.
Comments