Talia's Rabbit

This is the rabbit that my 9yr old daughter made on 3D Slash (https://www.3dslash.net/index.php).

I printed this one for her for Easter.  She is going to colour them in with some colourful permanent markers (especially the eyes).  She said it was OK for me to uploaded it here so others could make little rabbits too.

I printed it in PLA at 205 degrees on a 55 degree bed, using 20% infill and 0.05mm layers.  I scaled it down a bit to 4cm.  It does need a fair bit of support, because she doesn't know about that aspect of 3D design yet.