Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Use this to convert 2 pieces of 20cm IKEA BLANDA serving bowl into a nice spherical glass terrarium.
Printed without support at 0.2mm layer height, infill irrelevant. Each piece is a 40º revolution from the circular center. So theoretically you will need 9 pieces to fully go around the bowl. As it turned out for me, I had to trim down the last piece so it'll fit (as shown in one of the photos). Yours may vary depending on your print. FreeCAD source file available here if you want to change the revolution angle, or anything else.
The decorative 3D printed sitting fox is by steven_dakh and is available here.
Happy terrarium gardening!
Comments