Zonestar P802NR2 Stablizing Foot

Summary This is a foot for the P802NR2 and should fit others like it. My printer is not stable so I made these to be screwed to a work surface and then pulled down tight with the top and two screws. The bottom goes under the long threaded rod. Place as close to the foot as possible as to not bend the rod. Hope you like it and it can be of some use to you. Have not tried this on an Anet. Let me know if it works. B-) Print Settings Printer: Dremel 3D20 Rafts: No Supports: No Resolution: .2 Infill: 20