Designed by
[email protected]
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Just a basic replacement Quixo Block.
Print with either the X or O side down and no support will be needed and no problem with drooping on the lettering.
Lettering is inverse extruded (intruded?) deep enough to allow for a few coats of low build primer and then your whatever color coating and faux wood finish you choose.
Printed at .15 layer height and although it does not need it, 30% infill to get close to approximate weight of original piece.
Finished with low build primer, faux wood finishing, and hand applied lacquer.
(All in all, I know I could have done it faster in actual wood, but that isn't the point.)
Design Files
File Size
Quixo block by BK.stl
106 KB
Comments