camera case for EACHINE

Summary I created these two cases for EACHINE FPV 600mW transmitter and the smallest camera they sell.. i want to use it on some small plane or 150 racer quad. You can buy the transmitter and the sensor from here for approx. 30 USD http://www.banggood.com/600TVL-8_0MP-14-2_8mm-CMOS-FPV-170-Degree-Wide-Anlge-Lens-Camera-PALNTSC-p-984345.html http://www.banggood.com/Eachine-ET600-5_8G-32CH-600mW-Super-Light-Transmitter-p-974640.html The assembled system weighs just 16 Grams printed in ABS ... There is a square hole on the right side of the lens that will allow the frequency change so use a pen or a sharp thing so you can access the switch. IMPORTANT . To print this case rotate along Y axis with 90degrees so the camera will be positioned upside down. Print Settings Printer: xyz da vinci Aio Rafts: No Supports: No Notes: IMPORTANT . To print this case rotate along Y axis with 90degrees so the camera will be positioned upside down.