Sword of Omens (Dagger) ...or Fridge Magnet

Summary 2016-09-19: Added some refined parts including threaded and hollowed versions of the handle/pommel, swiveling quillions (those bits that stick out the side), and a crossguard cavity to support adding electronics for lighting the eye. The mating points between the blade and rainguard area still need some clearance modification so prepare to shave or sand in order to get them fitting well. Still WIP. 2016-08-30: omicron22 made an Eye of Thundera to fit my dagger, check it out here: http://www.thingiverse.com/thing:1743554 Original: I wanted a dagger hilt for a silly side project, but didn't find anything I really liked. So I figured I'll just make something myself. And if I was going to spend the time modeling something, it might as well be something cool. Post-Printing All versions 2016-09-19: The supported grip has some walls next to the protruding tabs that need to be pried off after printing. So far when oriented correctly everything but the crossguard should print without support. Refrigerator Magnetic Blade 2016-09-19: The cut, fridge-magnet blade, should accommodate a 4x10x20mm neodymium bar magnet at the tip and a 15mm dia x 2.75mm h disc at the base. This holds up the plastic-only dagger on my refrigerator, once I get electronics and a battery in the handle, I might need to upgrade to a beefier tip magnet. I'll keep you posted. Original version I made some holes for alignment when gluing it together. It should accept lengths of 2.85mm filament as pegs. I'll see if they need to be adjusted after my test print finishes. How I Designed This Refinements: Countless additional hours. Original Version: Fusion 360 and about 10-14 hours. I used this instructable for a lot of the detail reference. http://www.instructables.com/id/ThunderCats-Sword-of-Omens-Dagger-Form I really liked how his dagger turned out.