Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Summary Hi, This part is to replace the fixed spanner for bowden extruder. it's for my Tevo Tarantula, but i'm sure it can be used with a lot of bowden type printer. With this part, there is no need to buy any additional stuff. just replace the existing spanner... the hole for the pushfit is not threaded, I just toroughly push and screw ^^ Enjoy Print Settings Printer: Hephestos 1 Rafts: No Supports: Doesn't Matter Resolution: 0.2 Infill: 20% Post-Printing If needed... May need some drill/clean for the filament's hole. How I Designed This Why i did it Well, i was a bit upset having the PTFE tube moving down and clash with the pulley... maybe my pushfit is not the right one. but i read on internet that other people faced the same issue. Part is quite simple so i redesign it.
Comments