Designed by
Skaross
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Summary A simple gate for indoor racing. Combine 2 x 1m lengths of cheap foam pipe lagging with the joiner (gate-joiner), glue and duct tape. Make up 2 bases with 2 legs each (pins are push fit). Bond/tape base each end. Tie string between bases to hold curve. Foam from any DIY store, eg: http://www.toolstation.com/shop/p57097?table=no Print Settings Printer: Da Vinci Rafts: No Supports: No Resolution: 0.3mm layer Infill: 25%
Design Files
File Size
gate-joiner.stl
1.89 MB
gate-leg.stl
2.49 MB
gate-base.stl
6.77 MB
gate-pin.stl
21.8 KB
Comments