Minotaur 54mm

Summary Back after short RL Hiatus, I finished this late last month 52 mm Minotaur stands about 70mm. Lightly Inspired by KOBL Minotaur. I highly suggest HIPS printing for my figures on FFF machines however this fella should be large enough to manage without. I also suggest dialing down the speed for HIPS printing, see below This model is designed for HIPS printing. https://timeportalgames.com/wp/ 28mm model versions available through timeportalgames.com or buy at https://www.shapeways.com/shops/timeportalgames. ASSEMBLY REQUIRED:Will likely require xacto blade, or sanding, and superglue to assemble weapons/shields to figure. We advise the following settings for slicing Layer height: Between .2mm auto_support: Between 1- 1.5mm or 40-50% HIPS fill Fill Density: 15% or greater 3 shells Print speed 30 outlines 75 fill Other notes glass plate with HIPS slurry allows for plate to heat only to 100c without issue. Many free designs available at https://timeportalgames.com/ Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator Rafts: Yes Supports: Yes Resolution: 350000 poly Infill: 15% Notes: Dissolvable filament print. Post-Printing Acetone brushed flesh areas, acrylic paint