No Prints Yet
Be the first to upload a Print for this Design!
A mod to allow E3d's Titan extruder to be used on a Duplicator I3. The X end stop microswitch had to be unscrewed from its original mount and hot glued into this mount. The new mount sits on top of the upper X rod via M3x15mm screws. It should be noted that because of how the Titan sits the printer won't print center anymore. The printer will now print right to the edge of the print bed, but I have had no issues with it as is. This was an older design that I never intended to upload and it could be shorted to gain a few mm back to center.